NJ306 CRANKSHAFT BEARING RACE MOUNTING TOOL, MX-12231, ID:40.4MM FOR NJ306 BEARING

RACE PULLER & INSTALLING TOOL

- Professional tool for removing and installing the bearing shell off the crankshaft.
- This tool allows removal and installing of the bearing shells without any damage or heating of the crankshaft
- Easy to use, simply heat up the center ring of the tool.
- The tool is then slipped over the bearing shell and it heats up the shell and it expands so comes loss on the shaft.
- As soon as it is loss just clamp the handles together and rotate off the shell.
Note. many videos on you-tube showing them in use.

ID:40.4MM FOR NJ306 BEARING

KTM
625SMC    2004-06
640DUKE II    1998-06
640 LC4 ADVANTURE 2003
640 LC4 ADVANTURE 2006
640 LC4 ENDURO    2003-06105XC    2008-09

- Manufactured to the tightest tolerances for a better fit.
- Best value for money
- FIR racing products are a high quality replacement part and carries our guarantee of your satisfaction.
- Please check the image before ordering to avoid mistakes.

Part No. 00-0127.306.FIR [FACTORY IMAGE RACING]  (Distributed by oro2u.com)

Cross Reference Numbers Only:
MX-12231