FLYWHEEL PULLER M26 x 1.00 RH, Right Hand External Female, KTM 580.12.009.000, 58012009000

KTM Husqvarna Flywheel Puller 26mm x 1.0 mm Right Hand External Female.

RepairManual.com is proud to offer this KTM Husqvarna Flywheel Puller 26mm x 1.0 mm Right Hand External Female for sale.

Flywheel puller for KTM 1988 to current motorcycles: 250, 400, 450, 525 4 stroke EXC, XC, SX, SMC. Also fits most late model Husqvarna 250, 450, 510 4 stroke TE, TC, SM, SMR. Also can be used to remove clutches from small frame Vespa scooters.

Part No.00-081.DR (oro2u.com)

1988 KTM 600EXC LC4
1989 KTM 600EXC LC4
1990 KTM 600EXC LC4
1992 KTM 500EXC
1992 KTM 500EXC LC4
1992 KTM 550EXC

KTM
250 SXF 05-10, 250 XC 08-11, 250 XCF 07-09,250 XCFW 07-11, 250 XCW 08-11, 400 EXC 98-02, 400 EXCG 04-06,400 MXC 01-02 400 SX 98-02,400 XCW 07-08, 450 EXCG 03- 06,450 EXCR 07-08, 450 MXCG 03-05, 450 SMR 2008,450 SXF 03-11, 450 XC 2007, 450 XCF 08-09, 450 XCW/XCRW 07- 09,505 XCF 08-09, 520EXC/MXC/SX 00-02,525 EXC 03-07,525 MXCG 03-05,530 EXC 10-11,530 EXCR 2008, 530 XCRW 2008,

- Flywheel / Alternator / Magneto rotor puller / extractor M26x1.5 / M27x1.25
- Fits Bosch, Ducati, Motoplat.
- This tool is bolted to the flywheel and then the centre bolt is tighten forcing the flywheel off.
- High carbon tempered steel, Heat treated for strength and durability
- CNC precision machined components.
- Great tool for easy removal of the flywheel with no need for power tools.
- Black oxide finish preventing corrosion to assure many years of service.
- Best value for money
- All are made to OEM specifications and match the original equipment in appearance.
- FIR products are a high quality replacement part and carries our guarantee of your satisfaction.
- Please check the image before ordering to avoid mistakes.
- Please check the thread size of your motor before ordering.
- [FACTORY IMAGE RACING]

Tips on use.
- Make sure the flywheel thread is clean of dirt and not damaged before screwing the puller in.
- Use copper grease on the puller threads, for long life.
- Make sure the puller is fully screwed into the flywheel.
- After tightening use a hammer on the centre and tap to jolt free [not always need].
- If using old flywheel pullers make sure the threads are in good condition before use to avoid damage to flywheel.