Swing Arm Bearing Tool.

Swingarm/Linkage Bearing Removal / Install Tool

Designed for installation of the swing arm bearings without damaging the steel on late model Japanese motorcycles. Using the correct size insert (various sizes included in kit) and the puller, the mechanic can draw the bearing into the swing arm without beating on it with a hammer.

SPEC: THREADED ROD X 1PC
THRUST BEARING X 1PC
DRIVER 1 (22.0MM/26.8MM) X1 PC
DRIVER 2 (21.0MM/26.0MM) X1 PC  
DRIVER 3 (20.0MM/26.0MM) X1 PC
LARGE WASHER X1 PC /
SMALL WASHER X 1PC / NUT X 2 PCS
MATERIAL: S45C
FINISHED: ZINC PLATED  

NOTE :        
- KEEP CHECKING AND MAKE SURE THE BEARING IS STRAIGHT WHILE TIGHTENING THE NUT.      
- BE SURE TO DRIVE THE BEARING TO THE EXACT LOCATION REQUIRED BY THE MANUFACTURERS SPECIFICATION OR MEASURE THE BEARINGS LOCATION PRIOR TO PERFORMING THE REMOVAL PRECEDURE.      
- CLEAN AND LUBRICATE THE THREADED ROD BEFORE USE.

FEATURES :      
DESIGNED FOR INSTALLATION OF
THE SWING ARM BEARINGS ON
LATE-MODEL JAPANESE MOTORCYCLES.      
PULLER DRAWS BEARING INTO THE
SWING ARM. INCLUDES THREE DRIVERS
FOR USE WITH COMMON BEARING SIZES

- Best value for money
- All are made to OEM specifications and match the original equipment in appearance.
- ORO products are a high quality replacement part and carries our guarantee of your satisfaction.
- Please check the image before ordering to avoid mistakes.

Part No. 00-115.DR. (oro2u.com)

Cross reference numbers.
08-0213, UP-12052